AN ENJOYABLE EXPERIENCE
AN ENJOYABLE EXPERIENCE
INTUITIVE CONTROL INTERFACE
MULTIPLES EFFECT/ABILITY TO SYNC
32 LEDS PER FAN
HIGH STATIC PRESSURE
SANDBLASTED ALUMINUM PARTS
A QUICKER AND EASIER INSTALLATION PROCESS
When using the UNI FAN SL120 in a custom watercooling configuration, make sure that the fittings on the radiators do not interfere with the contact point on the side of the fans.
We suggest to use the insulating tape to isolate contact points.
The 4 possible clusters of UNI FANs that can be connected to the controller are reflected on the L-Connect interface. VIA L-Connect, users can adjust a single UNI FAN SL120, a single cluster of up to 4 fans, or all 4 clusters of fans according to their needs.
Please download this driver and run L-Connect again when occurring interruption between L-Connect and other ARGB software.
Issue appears as:
1. Light and Fan of UNI FAN is operating.
2. Lian-Li appearces under device management.
3. However, can’t control UNI FAN by L-Connect.
4. Need to re-plug the USB when rebooting.
If the motherboard used in your build doesn’t have the requisite 3-PIN 5V ARGB headers, you can leave this port unplugged.
But then you won’t be able to switch to motherboard synchronisation with the toggle shown on the L-Connect.
For user who do not want to use the controller box, the UNI FAN SL120’s RGB connector can also be connected directly to the motherboard 5V header. For motherboard that supports 5v ARGB LEDs, it should come with an adaptor cable as picture shown above. The ARGB connector from the SL120 can connect to this adaptor cable then directly to the motherboard 5v 3 pin header.
To fully control up to 16 UNI FAN SL120s (4 fans each cluster) in one go either through the built-in L-Connect software or the motherboard software, users must use the designated UNI FAN controller included in the 3 pack packages. Please note that the single pack version does not contain this controller and thus we recommend users to purchase at least one 3 pack for their build.
“UNI HUB” requires the PWM signal while performing PWM mode on L-Connect. Please enter your MB BIOS and check the fan header is at PWM mode. DC mode or any other mode will not be detected by the UNI HUB.
**Update your MB BIOS system if necessary.
|Model||UNI FAN SL120|
|Fan Dimension||122.8 X 122.4 X 25 ( mm )|
|Rated Voltage||DC 12V(FAN) & 5V(LED)|
|Max. Air Pressure||2.54mmH2O|
|Max. Air Flow||58.54CFM|
|Acoustical Noise (Min-Max.)||17dB ~ 31dB|
|Locked Current||>= 0.5mA|
|Bearing Type||Fluid Dynamic Bearing(FDB)|
|Operation Voltage||DC 12V & 5V|
|Start-up Voltage||DC 6.0V|
|Input Current||0.18A(FAN) / 0.6A (LED)|