Chassis For E-ATX| Quality | Design | Feature | Silent | Thermal | Friendly | Specification | Accessories

Creative Thermal Solution   PC-A7110 is using "Thermal Tunnel" solution, the two 120mm fans in the front input cold air into the system, the two 120mm fans and the PSU's fan draw the hot air out as a heat circulation . To have extra cooling performance to the motherboard and graphics card, there are two 120mm fans behind the HDD cage to improve the air flow to cool the system down.               There are two 120mm intake fan on PC-A7110, The fan can output high air flow volume  with lower RPM to push the cold air through the HDD rack. They can controlled by a three-speed controller, factory setting to Middle (1240RPM), User can adjust the fan speed to suit.               The case front intake fans has equipped air filter, to stop dust entering the chassis. These air filter were washable, envirnoment friendly.                   There is a 120mm exhaust fan at the rear to draw the hot air out, and improve the air flow inside the chassis. It can be adjust by a three-speed fan controller, factory setting to Middle (1240RPM), user can adjust to suit.             The HDD cage also fitted a 120mm exhaust fan to draw the hot air out, to keep the HDD cold, and remove the hot air from the system.It can be adjust by a three-speed fan controller, factory setting to Middle (1240RPM), user can adjust to suit.               There are alot of M/B using heat pipe solution, PC-A7110 can 100% support them, for extra cooling, there are openning on the M/B tray, allow air to cool the rear of the M/B. .               There is a smart way to control the fan speed. PC-A7110 equipped a three-speed fan controller, user can easy adjust the fan speed to suit their need, when there is not hot inside the system,  switch it to low speed, to make it silent and to extend fan's life cycle. Factory setting to Middle (1240RPM), user can adjust to suit.             Power supply unit located at the lower part of the chassis, and it can get the cool air from the bottom of the chassis. Ideal for keep power supply in lower temperature to keep in best output performance, also keep the components cold to extend the life cycle.             There are opening for water tubes on rear panel. Ideal for user who would like to fit liquid cooling system into PC-A7110.       <Prev                Next>