|
|
|
|
|
Creative Thermal Solution
PC-V series chassis has two heat zones, one zone for motherboard, graphics card and optical drives, and one zone for 3.5” HDD and power supply unit. To separate the heat sources for better thermal solution.
|
|
|
|
|
|
|
|
|
|
Lian Li fitted a 140mm intake fan on PC-V2110, The fan can output high air flow volume with lower RPM to push the cold air through the HDD rack. There is a three speed fan controoler, factory setting to Middle (980RPM), user can adjust it to suit.
|
|
|
|
|
|
|
|
|
|
The case front fitted with vented 5.25” bezels, allow the cold air to enter the chassis, there are air filter on the bezel to stop dust entering the chassis.
|
|
|
|
|
|
|
|
|
|
There is a 120mm exhaust fan at the rear to draw the hot air out, and improve the air flow inside the chassis. There is a three speed fan controoler, factory setting to Middle (1020RPM), user can adjust it to suit.
|
|
|
|
|
|
|
|
|
|
PC-V2110 fitted a three-speed fan controller, user can adjust the fan speed to get the best balance between silent and cooling. Factory setting to Middle, user can adjust to suit. (120mm fan : 1020~1240~1500RPM) (140mm fan: 800~980~1180RPM)
|
|
|
|
|
|
|
|
|
|
Where air enter the chassis, there is a need for an air filter to hold the dust.
PC-V2110 fitted a washable air filter, it can easy remove from the fan unit, no tool required, and it is recyclable.
|
|
|
|
|
|
|
|
|
|
Height adjustable Chip set cooler !
PC-V2110 fitted a 120mm fan on the graphics card holder to cool the memory and north bridge chip set. There is a three speed fan controoler, factory setting to Middle (1020RPM), user can adjust it to suit.
|
|
|
|
|
|
|
|
|
|
Power supply unit located at the lower part of the chassis, and it can get the cool air from the bottom of the chassis. Ideal for keep power supply in lower temperature to keep in best output performance, also keep the components cold to extend the life cycle.
|
|
|
|
|
|
|
|
|
|
There are opening for water tubes on rear of the top cover. Ideal for user who would like to fit liquid cooling system into PC-V2110.
|
|
|
| <Prev |
|
|
|
|
|
|
|
Next> |
