Lian Li Industrial Co., LTD - XB01 -XBOX360 CASE REPLACEMENT

	6. Use a Torx 10 and 8 driver to remove all the screws, there will be six Torx 10 screws holding the top cover, and eight Torx 8 screws holding the main pcb board and the steel chassis together.
	7. Before flipping the whole case back right side up, remove the eject button.
	8. After removing the top cover, remove the cover of the RF module. There are three Torx 8 screws to hold it in place, release the three screws, and unplug the RF module. To remove the DVD drive, unplug the cables from the DVD drive from the main board and the sticker to the steel chassis.
	9. After removing the RF module, use a flat screw driver to unlock the air duct from the steel chassis, disconnect the fan power connector, and pull the main board out the case. The non-HDMI version of the fan connector has a 4 pin connector The HDMI version has a 3 Pin connector Please use the fan power connector cable which is included in the accessories bag to connect the fan and Xbox 360 mainboard.
	10. Remove the DVD tray cover off from the DVD drive. Change the SATA cable to a longer version, and connect the power cable to the DVD drive.
<PREV	NEXT>